LED optics diameter 200 mm - yellow

Features: LED optics diameter 200 mm - yellow, for use for temporary road signs.

This light is specially designed to replace or repair a traffic light based on LED lights. Check if the traffic light is compatible with this module.

A closed module is supplied, with front optics, LED lights and electronics. Case made of UV-resistant black PE plastic. IP65 resistance to water and moisture. Prepared to be installed outdoors.

Internal connection via electrical terminals. Model for connection to a 220 VAC electrical system. It has 2 connection terminals.

Diameter of the front lens: 185 mm. Maximum diameter: 210 mm. Total depth: 90 mm.

Yellow LED replacement light. Power consumption: 5.8 W approx.

Working Temperature: -40ºC~+80ºC.

The amber LED flasher diameter 200 mm, is composed of 2 shells (one front - lens, one rear - base), these are made of plastic material resistant to shocks and atmospheric agents.

The coupling between the two shells is ensured by nr. 3 screws and nuts properly tightened.

The electronic board with LED diodes is bound inside the flasher thanks to nr. 4 self-tapping screws applied to the positioning turrets on the rear shell.

The correct position of the flashlight is suggested by the arrow on the back of the flashlight (see positioning specification).

The flasher at the rear is equipped with a cable gland for the exit of the electrical system, at the end of the cable there are monopolar connectors for the application of other flashers and / or for the application of the power cable with eyelet cable for the connection on a 12V battery.

MASTER BEACON: flasher that drives the slave headlights connected to it (the flasher is equipped with an integrated circuit that allows the management of the flashing system).

SLAVE BEACON: beacon that flashes only when connected to the master pilot flasher.

The waterproofing of the flasher is guaranteed by:

• rubber gasket, present on the entire circumference between the front lens and the rear shell;

• rubber plates (o-rings) on the screws and relative tightening nuts;

• from rear PG9 cable gland for the power cable to be pulled out

FEATURES:

The flasher is mainly used to warn of situations that require special attention (danger) and/or to indicate the presence of road construction sites. The shape of the flasher allows it to be applied to any surface and/or flat support, making it versatile and easy to install. The flashlight is supplied with standard flashing, on specific request it can be supplied with fash flashing or triflash flashing. 

 ELECTRONIC FEATURES:

• Power supply: 12V - 24V DC;

• operation: standard flashing, on request flash flashing or triflash flashing;

• photosensor for self-regulation of light intensity, on request night operation only; Average absorption:

- standard flashing 330mAa 12V - 135mAa 24V

- flash flashing 37mAa 12V - 18 mAa 24V

- trisflash flashing 102mAa 12V  - 44mAa 24V;

• flashing frequency: 1Hz (60 flashes per minute) light source: n°. 120 high-intensity amber LED diodes with 30° light emission angle;

• luminous optical diameter: 230 mm, useful 200 mm;

• Driving circuit with microcontroller.